tracking pixel
Chris W

Mini Swag Lamp

by
RetroMaker
Follow
Follow
Remix Model
RetroMaker
RetroMaker
|
Image 1 of 2
Mini Swag Lamp 3d model
RetroMaker
RetroMaker
|
Image 1 of 2
Mini Swag Lamp 3d model
2D
3D
Makes
Mini Swag Lamp 3d model
Mini Swag Lamp 3d model
This model is restricted by licensing terms. 

The Mini Swag Lamp can be printed and used with the hanging votive LED candle swag setup or without as a table top tealight holder.

The lamp is to be used with a small tealight/votive LED candle only! do not expose model to heat or fire.

Files contained: Frame - Print with 8mm brims and 20% infill

Gem (Print Quantity 18) - Print with resin for best results.

Skinny Gem (Print Quantity 9) - Print with resin for best results. This is for the center ring of gems.

Votive Hangers (Print Quantity 3) - Print in place flat.

Votive Holder - Print with minimal supports.

Chain 2 Lengths - print at 45 degree angle to the plate and use 6mm brims. No supports.

Chaintop - print flat and use 4mm brims to prevent warping.

Wallhook - Print flat. Print 2 additional gems for this.


36 Likes8 DownloadsMay 19, 2023


36 Likes8 DownloadsMay 19, 2023
This model is restricted by licensing terms.